Doc. Rev. 1.3
3 / 4
© Intesis Software S.L. - All rights reserved
The information in this document may change without previous notice.
IntesisBox
is a registered trademark of Intesis Software SL
URL
tel
http://www.intesis.com
[email protected]
+34 938047134
Installation Manual
IntesisBox
®
KNX – Toshiba AC
Connections and indications
________________________________________________________________________________________
Notes:
1.
IntesisBox has different LED which indicate:
Power LED:
On steady when device is powered.
RS485 LED:
Blinking when there is activity in the EIA485 bus, this is when there is comunication between the IntesisBox and the
AC units.
TCC-LINK LED:
Blinking when there is activity in the Toshiba bus, this is when there is communication with the AC units.
ERROR LED:
On steady when there is a communication error.
TEST LED:
Blinking when the gateway is on test mode.
2.
IntesisBox has a programming button “Prog” and an associated LED for indication of KNX programming ongoing.
3.
Connection slots for the
TCC-Link bus (3a)
and the
KNX bus (3b)
.
4.
Mains power conection: 230VAC (see sectionTechnical Characteristics). The device provides switch and a protection fuse. Use the supplied
cable with IntesisBox (1,6m).
5.
TCC-Link connection
: Connect the TCC-Link bus coming from the Toshiba AC to the U1-U2 connector of IntesisBox. Respect the polarity,
and consult your distributor for more details.
KNX connection:
Connect the KNX bus to the KNX connector of IntesisBox (C1). Respect the
polarity.
6.
Use the ferrites supplied with the device to protect the TCC bus (6a) and the KNX bus (6b) from electromagnetic interferences.
Device internal view
Device back view
4
3a
3b
5a
5b
6a
6b
