Inteset Wireless IR Repeater System User Guide
2
The IR CON LED, blinks upon receiving
a signal from the remote control, but the
target device does not react as expected.
Note: The blue LED on each unit should
blink once when first plugged into the
power cable. It just blinks. It does not
stay on.
Make sure the embedded IR Emitter in the base
Unit (White Logo) is pointing directly at the IR
sensor in the target device which you want to
control. (Cable Box, BR Player etc).
See our
Forum for tips on locating IR sensors.
If using the IR Emitter Cable. It should be
connected to the
“EXT EMITTER” jack and one
bud on the other end should be directly on top of
the IR sensor in the device that you want to
control. Be sure the signal from the remote is not
blocked at the Receiver end and that the emitter
cable plug is pressed firmly into the Emitter Unit.
Make sure the IR Receiver Cable is connected to
“EXT IR REC” jack of the IR Receiver Unit.
When the system has been set-up, press a
button on your remote control. The IR signal
should control the target device and the IR LED
on both base units should flash Blue.
3
The distance between remote control
and IR Receiver is short (less than 15
feet)
Be sure the batteries in the remote control are
good- replace the batteries in your remote.
Be sure that the Emitter bud is directly over the
IR sensor of the target device (Cable box etc.).
4
The target device does not work after
setting up the wireless IR system.
Review the steps taken during set-up to be sure
all aspects are correct.
5
I have connected the units the way the
user manual instructs, but I still cannot
get this kit to work.
Any kind of thick or dense material such as
concrete, wood or metal can affect the signal. Try
relocating one of the units closer to the other to
test if the system works. If it does, you will need
to relocate the device(s) you want to control.
6
The manual says it can work
“up to
hundreds of feet of open space
”. Why is it
less than 100 feet in my installation?
“Open space” means there’s nothing between
the IR Receiver and IR Emitter Units. The useful
distance is greatly reduced by furniture, walls
and floors, especially in construction or materials
where metal or stone is used.