Weld-i
TM
HD 625
Instruction & Admin Manual
Page 40 of 47
InterTest, Inc. • 303 Route 94 • Columbia, NJ 07832
+1 (908) 496-8008 •
Released 8-20-21
Admin Section
This section of the manual is intended for high level users that take responsibility for use at an OEM
level. Settings, programming, and remote communication through RS 232 allow expanded use.
Caution: users at this level are beyond warranty coverage. Contact InterTest tech support,
for further details.
Dip Switch Settings
This list documents the DIP Switch functions on the SCB300 board.
Firmware
version:
1.06
Number
On
Off
FirstVersion
1
Show Company Name on OLED
Don't show
0
2
N/A
N/A
0.56
(Used to show serial number or
not in Utility menu, removed for
Lens Correction)
3
N/A
N/A
4
N/A
N/A
5
N/A
N/A
6
AEQ Report Mode
Normal Mode
1.03
Set to On to use cable testing
mode. Follow supplied procedure.
7
DS954 (New Serdes FW)
DS914 (Old Serdes FW)
1.02
With DIP8 set to OFF this selects
old or new SerDes firmware to
upgrade.
8
Regular Run Mode
Firmware Upgrade Mode
1.02
Set this to Off to upgrade
Firmware; ON to use the system
normally.
Main Menu
Line
Text
Notes
FirstVersion
0
** Intertest QN HD **
0
1
Main Menu
Top level menu
0
2
Image Quality
Image quality related
0
3
Capture Setup
Image capture related: FPS, Exposure, Mirroring
0
4
Utility Menu
LED Level, Diagnostics, Save Preset, Load Preset
0
5
Pan-Tilt-Zoom
Resolution, Zoom, Pan, Tilt
0
6
7
Reset to defaults
0
Bold-Italics means item is a submenu
Control ID provided for commands that go to the ISP
