7
DISH FIREBOWL | Owner and Installation Manual
TO ASSEMBLE THE BURNER
1. Remove the Burner Assembly and Burner Media
(lava rock) from packaging (see Parts List on pg 15).
2. Connect the Burner Assembly to the gas/propane
supply using the supplied flex connector and
following the instructions on page 8.
3. Carefully leak test all connections following the
procedure on page 8.
4. Fill the burner pan evenly with burner media covering
burner ring. Media should be level with the top rim of
the pan. Do not obstruct lighting port with burner
media!
5. Carefully lift the burner and place it in its housing.
(See page 4)
6. Follow the Initial Lighting Instructions on page 10.
Make sure that the flame carries to all parts of
the burner. Turn OFF the appliance and let it cool
before proceeding to the next step.
7. Place and evenly distribute remaining lava rock on
top of burner and topping ring. Keep the lighting
port open and free of media.
WARNING:
Failure to position parts in
accordance with these diagrams
and instructions and/or failure to
use parts specifically approved for
use with this appliance may result in
property damage or personal injury.
CAUTION:
Do not remove the metal data
plates attached to the Outdoor Fire
Pit Burner. These plates contain
important information.
NOTICE:
Installation and repair should be
done by a qualified service person.
The appliance should be inspected
before use and at least once annually
by a qualified service person. More
frequent cleaning may be required
as necessary. It is imperative that
control compartment, burner and
circulating air passageways of the
appliance be kept clean.
BURNER ASSEMBLY
LIGHTING PORT
