Interroll ZoneControl, Руководство по эксплуатации

Страница: 12 / 54

12 von 54
Version 2.0 (04/2019) Online
Translation of the original operating manual
Safety-related information
2.5 Dangers
Here, you will find information about the different types of dangers or damage that can occur in
connection with the operation of the ZoneControl.
Injury to persons
¾
Maintenance and repair work on the unit must only be carried out by authorised technical personnel in
compliance with the applicable provisions.
¾
Before switching on the ZoneControl, ensure that no unauthorised personnel are situated in the vicinity of the
conveyor/conveying system.
Electricity
¾
Installation and repair work must only be carried out when the system has been disconnected from the power
supply. Switch off the power to the ZoneControl and ensure that it cannot be unintentionally switched on again.
Work environment
¾
Remove any materials and objects that are not required from the working area.
¾
Wear safety shoes.
¾
Stipulate that the material to be conveyed must be set down carefully and monitor this to ensure it is carried out
correctly.
Faults in operation
¾
Regularly check the ZoneControl for visible damage.
¾
If smoke develops, immediately switch off the power to the ZoneControl and ensure that it cannot be
unintentionally switched on again.
¾
Immediately contact specialist personnel to determine the cause of the malfunction.
Maintenance
¾
Since the product in question requires no maintenance, it is sufficient to simply examine the ZoneControl for
visible damage on a regular basis.
¾
Never open up the ZoneControl.
Unintentional start-up
¾
Ensure that the connected RollerDrive/motors cannot start up unintentionally, particularly during assembly and
maintenance work or in the event of a fault.