Interpump Hydralok HCL Mobile, Руководство пользователя

Страница: 8 / 17

Machines manufactured by Hydralok, Bristol, UK
Machine enquiries, sales, after sales service :
Interpump Hydraulics (UK) Ltd t/a IMM Hydraulics (UK) : Kidderminster
Tel : (0)121 550 1115 / sales@immhydraulics.co.uk
P a g e | 8 r1
Machine Description
A bench mounted, electrically powered rotating circular, toothed knife. Cutting operation is
powered by hand. The machine is intended to be used for cutting steel wire reinforced rubber
hydraulic hose or similar.
Installation
The machine must be fixed to a firm, and level work surface, bolted down by a minimum of two
bolts located in opposing corners of the machine. Mounting information can be found in Appendix 1
– Mounting Information.
Connections should be made to an appropriate 12v / 24v DC electrical supply by a qualified
electrician. Standard wire colour coding is applied where the
RED wire terminal must be connected
to the positive/live supply terminal, and the BLACK wire must be connected to the negative/neutral
supply terminal. For electrical schematic see Appendix 2 – Wiring Schematic.
A separate 160 - 180 amp battery coupled to a split charger is recommended. Alternatively a 110 -
120 amp battery can be used for light duty. To ensure a maximum 12 volt DC supply is delivered to
the machine, a minimum cable size of 25 mm square with a maximum length of four meters can be
fitted. A suitable isolator and overload protection device should be fitted to the voltage supply line.
Prior to operation, ensure that the blade is free to rotate without fouling on any of the guards and
that the guards are operating correctly and covering the cutting blade completely.
Operating Instructions
To move the hose support pillars (object 4 of Appendix 3 – Machine Diagram), unscrew the clamping
handle 1-2 rotations, slide the pillar to position, and re-tighten the clamping handle. Set the hose
support pillars an equal distance apart from the blade, so that when the handle (1) is pushed down
the hose is put under reasonable bending strain to relieve pressure on the sides of the blade during
the cutting operation.
Place the hose into the cutting jaws (6) so that the hose bends out towards the user and is
supported by the hose support pillars (4). Ensure that the cutting mark is directly between the hose
cutting jaws (6). Switch on the machine using the green portion of the control button (3) and push
the handle downwards
SLOWLY . Allow the blade to cut through the hose at a controlled rate
without excessive slowing of the blade. When the hose is cut, allow the handle to return to a fully up
position where the blade is fully covered and switch off the machine using the red portion of the
control button (3).