www
.interplayuk.com
This screw should be at the
top of the fan assembly
Peel the backing paper off one of the self
adhesive ‘hook-and-loop’ fasteners and stick
to the tray as shown. Peel the backing paper
off the other half of the self adhesive ‘hook-
and-loop’ fastener and stick to the underside
of the battery compartment.
10
9
Mount the fan assembly with a paper
fastener through each of the 2 lugs
on the airbox, and another through
the hole at the bottom of the airbox.
Spread the legs on the paper fasteners.
Install the 4 AAA batteries in the battery
compartment as explained at the beginning
of this manual, then insert the fan assembly
electrical connector into the socket on the
battery box.
11
Peel the backing tape from the self-adhesive
foam strip and, starting from the rear of your
hovercraft, carefully stick the tape to the
outer perimeter of the tray, so that it acts
as an impact-absorbing bumper. Take care
not to let the foam strip project below the
bottom edge of the tray, or it will drag on
the floor and prevent your hovercraft from
performing properly.
12
www.interplayuk.com
9
E
C C 7 D
:
9
E
C C 7 D
:
TE
CHNOKIT
12
13
