Interphase ENTIA 5536 DM PRI, Руководство пользователя

Страница: 68 / 244

Setting Up Card and Port Properties
48
Interphase Corporation
4. If the board has dual ISDN ports, repeat Steps 1 through
3 to configure the remaining ISDN PRI port.
Next, continue to Configuring Digital Modem Port Properties
if you are (or will be) installing the Digital Modem RAS
Support driver.
If you do not plan to install the Digital Modem RAS Support
driver, or have already configured digital modem port
properties, go to
Completing the WAN Setup on page 49 .
Configuring Digital Modem Port Properties
If you are installing the Digital Modem RAS Support driver,
configure corresponding digital modem port properties as
follows:
1. In the Cards section of the WAN Adapters Setup dialog
box, select the digital modem port (
x Digital Modems,
where x is the number of digital modems on the board),
and click Properties .
The Digital Modems Properties dialog box appears:
Figure 4-9. Digital Modems Properties Dialog Box
2. Use this dialog box configure the analog-to-digital
speech channels coding law according to the geographic
region.
– For Europe and Australia, select A Law .