Interpack ET xtreme Series, Руководство по эксплуатации и список запасных частей

Страница: 23 / 81

23
R05
FRONT OF
T.H.
M5 FHCS
S
ET
-U
P
P
ROCEDURES
Option 2:
To change the rollers’ pressure one can move
the spring retainer’s position on the cover
frame. Move the M5 FHCS towards the front of
the tape head to increase the pressure or
towards the rear to decrease the pressure. See
Figure 8-2 .
Option 3:
When the loop is still persevering in
the rear tape leg, one can raise the
spring retainers position on the rear
arm . This will increase the torque on
the rear arm. Loosen the M6 FHCS
on the rear arm and move a position
up, farther away from the pivot axis.
2
1
3
The previously listed 3 options may need to be employed in combination to get the best result.
For instance, to get the 3-inch tape head in top tape head mode at 120 ft/min line speed make
the following set up, refer to Figure 8-3 . Put the M6 FHCS ( item 1 ) on rear arm on the second
position from pivot shaft. Put the M6 FHCS ( Item 3 ) on the Cover Frame closest to the rear end
position. Take the heavy stainless steel main spring UPH1091 ( item 2 ) and attach it to these
spring retainer points.
A reminder to tone down unrealistic expectations; boxes without stamina cannot be processed at
high speeds!
Figure 8-2
Figure 8-3
M6
FHCS
REAR OF
T.H.