Interpack CE-12P, Руководство по эксплуатации и список запасных частей

Страница: 9 / 43

CE-12P Manual 9
USM8131
5.4 Stack Light Status
Your CE-12P Case Erector is supplied with a status
indicator stack light. Table 5.3 shows the legend of each
light color machine status. CE-12P will flash
RED as an
indication of a fault. The AMBER light without the RED light
flashing is an indication of “Low Tape” or “No Tape.” The
GREEN light shows the operating status of processing
boxes in automatic mode.
Solid Amber – exit sensor is blocked.
Flashing Amber – Low Tape
5.5 Sequence of Operations
1. Vacuum cups approach the hopper and secure to the case.
2. Vacuum cups withdraw a case from the hopper while the top finger retains the
trailing major panel thereby breaking the vertical score lines.
3. As the case is withdrawn, a pneumatic squaring arm activates to form the case
into a sleeve.
4. With the case in the stationary position, pneumatic tuckers activate to close the
minor flaps followed by pneumatic tuckers to fold the major flaps.
5. Upon a signal from the PLC, a pneumatic pushing assembly squares the case
and diverts it into the side belt drives.
6. The side drives transport the case past a bottom taping head for bottom sealing
and discharge onto a take-away conveyor supplied by the customer.
Stack Light Status
Legend
Red Fault
Amber Warning
Green Ready
Table 5.3
Note: Breaker CP3 if tripped “No Tape”
and “Low Tape” warning will not work.
Machine will continue to run as normal.
Note: Amber light, Red light and “Cycle Stop” button will flash due to a fault
condition, once the fault is cleared press and hold “Cycle Stop” button for 3 seconds to
clear fault.
Note: When “Continuous Cycle” is pressed machine will run continuously. If for some
reason the exit sensor is blocked, the machine will form a case and then stops until the
blockage is cleared.