Internorm MIRO-K, Руководство по эксплуатации и обслуживанию для пользователей

Страница: 31 / 53

58 59
GB
7. EC DECLARATION OF CONFORMITY
The manufacturer: Schlotterer Sonnenschutz Systeme GmbH
Seefeldmühle 67b
5421 Adnet, Austria
We, Schlotterer Sonnenschutz Systeme GmbH declare that the products described below
Product:
Roller shutters
Type:
Attachment roller shutter VORO, VORO BRAVO, VORO PUTZ
attachment roller shutter RESA, MIRO-K
for the use of: outside sun protection
correspond to all relevant requirements of the
EC Machinery Directive 2006/42/EG .
■ According to appendix I no. 1.5.1 of the Machinery Directive, the Protection Objectives of
the guideline (2006/42/EG) concerning electrical equipment for use in certain voltage
ranges (Low Voltage Directive) is also covered.
Furthermore, the described products correspond to all relevant requirements of the
Electromagnetic Compatibility Directive 2004/108/EG .
In particular, the following harmonised standards were applied:
■
EN 13659:2009 Terminations outside – Performance and safety requirements
■ EN 60335-2-97:2010 Safety of electrical equipment for household use and similar purpo
ses, Part 2-97: Specifi c requirements for roller shutters, sun blinds,
blinds and similar equipment.
■ EN 12100:2010 Safety of machinery – General design principles –
risk assessment and risk reduction.
Authorised representative for compilation of technical material:
Milan Trpcevski, address – see manufacturer.
7. EC DECLARATION OF CONFORMITY
Dipl.-Ing. Peter Gubisch
Management
Dipl.-Ing.(FH) Milan Trpcevski
Head of Technology and Development
Adnet, July 2013
ROLLER SHUTTERS
8. CE MARKING,
SERVICE DECLARATION
The product has been CE tested and fulfi lls the requirements of the valid European guidelines.
CE conformity has been proven, the relevant Service declaration was passed on to you
together with the Operating and Maintenance Instructions. This will be kept for 10 years by
the manufacturer and can be requested if necessary via your distribution partner.
19760101
The Service declaration and the CE marking confi rm to you the acquired service according
to the Construction Products Regulation 305/2011. This service describes the wind resistance
class depending on width, slat type and guiding type of your sun protection product. The
wind resistance class can be found on page 7 of this document.
Excerpt from a Service declaration:
7. CE MARKING, SERVICE DECLARATION