SECTION 2
"
Installation Procedures
Vehicle Power Supply Installation Guide
2-3
Before you Begin
WARNING:
Equipment failure or damage will result if the vehicle power
source voltage does not fall within the input voltage rating of
the power supply furnished to you.
Power Supplies
Read the nomenclature on the power supply and verify that
the input voltage rating is correct for the vehicle you will be
installing it in. See Section One for identifying information.
Remember that the supply with the lower input voltage rat-
ing (6--36 V dc) has a 4-pin input connector while the power
supply with the higher input voltage rating (15-96 V dc) has
a 2-pin input connector.
Connect Power Input Cable
Only one of the input connectors will fit the power supply:
1. Mate the corresponding cable connector to the power
supply connector.
2. Slide the cable connector
IN
as far as it will go.
3. Turn the cable connector collar
clockwise
to secure it.
4. Clamp the ferrite bead onto the input cable near the
power supply. Make sure tabs are fully engaged.
5. Cut cable at the
unused
cable connector.
Discard this connector.