5. On the inside of the door assembly, disconnect the Ethernet cable from the module.
6. Disconnect the Ethernet module ribbon cable connector plug from the applicable terminal
connector.
7. Remove the three screws that secure the Ethernet Module and remove the module from inside
of the door assembly. Set aside the screws for re-use.
8. Open the new ET9232 Ethernet module plastic enclosure and remove the board.
9. Discard the plastic enclosure.
10. Remove and discard the ribbon cable from the Ethernet module board.
11. Align the module board over the holes on the door assembly and secure the board with the
screws previously removed in step 7.
12. Connect the ribbon cable connector plug to the applicable terminal connector. See Figure 4.
13. Insert the Ethernet cable into the Ethernet port on the module.
14. Close the door assembly and secure with the screw previously removed in step 4.
15. Return the deadfront to the enclosure and secure with the screws previously removed in step 3.
16. Close the time switch enclosure door.
17. Return power to the time switch.
Figure 4. Removing the Ethernet Module.
Figure 5. Ethernet module plastic enclosure.
