ET100 SERIES EASY-SET BASIC PROGRAMMING
RESET TIME SWITCH:
1. Place the two position switch to
AUTO
and the three position
switch to
RUN
.
2. Press the
RESET
switch for 3-5 seconds to reset the
microprocessor memory and clear all programmed information. The
display will flash 12:00 AM.
NOTE:
Do not press the
RESET
switch after programming has begun
or you will loose all of your programmed information.
TO SET PRESENT TIME OF DAY:
1. Place the two position switch to
AUTO
and the three position switch
to
TIME SET
.
2. Press the
HOUR
and
MIN
buttons separately to select the current
time of day. Note that this timer is a 12 hour AM/PM time clock.
TO PROGRAM TIMES :
1. Place the three position switch to
PROGRAM
. Note that the display
now shows 0:00 1 for Event #1. There are 8 possible programmed
times (events), 4 ON and 4 OFF. All available events need not be
used.
2. Press the
HOUR
and
MIN
buttons separately to program the first
ON time desired.
3. Press the
EVENT
button once. Note that the display now shows
0:00 2 for Event #2.
4. Press the
HOUR
and
MIN
buttons for the first OFF time. If more
than 1 ON and 1 OFF time (event) is required per day repeat this
procedure for up to 4 ON and 4 OFF times (events).
5. Return the three position switch to the
RUN
position and make sure
the two position selector switch is in the
AUTO
position.
TO REVIEW PROGRAMMED TIMES:
1. Place the three position switch to
PROGRAM
.
2. Press the
EVENT
button to review each of the 8 set points.
TO CHANGE PROGRAMMED TIMES:
1. Place the three position switch to
PROGRAM
.
Содержание ET100 SERIES
Страница 3: ...3 ...
