4 / 7
P/N 466-5444
• REV A • 8NOV18
T and T Tamper Switch
These two pins connect to the tamper switch, which opens
when the housing cover is opened.
COM (I/O) Common or Ground
These two pins are connected to ground and serve as the
ground reference when using pins R, S, X, and D.
DIP Switch Options
The factory default (
D
) setting is on for all switches.
S2-1 (sounder enable)
On.
Sounder is enabled for all modes (
D
).
Off.
Sounder is completely disabled.
S2-2 (LED control)
On.
LED is enabled (
D
).
Off.
LED is disabled except during warm-up.
S2-3 (timer reset mode)
On.
Relay timer does not reset with motion (
D
).
Off.
Relay timer resets with motion.
S2-4, S2-5, S2-6 (relay time)
These switches determine how long the lock relay stays
energized when motion is detected (Table 1).
Table 1:
Relay Time Settings
Relay time
S2-4
S2-5
S2-6
1/2 seconds (D)
On
On
On
1 second
On
On
Off
2 seconds
On
Off
On
4 seconds
On
Off
Off
8 seconds
Off
On
On
16 seconds
Off
On
Off
32 seconds
Off
Off
On
64 seconds
Off
Off
Off
S2-7 (door monitor mode)
On.
Monitor the door switch (
D
).
Off.
Do not monitor the door switch.
S2-8 (relay mode)
On.
Fail safe mode (
D
) is enabled.
Off.
Fail secure mode is enabled.
Initial Power Up
After mounting and wiring the sensor, apply AC or DC power
to the input power terminals (V+ and V-). Allow at least 2
minutes following power up for the sensor to stabilize before
conducting any tests.
To walk test the detection pattern, approach the door from all
directions and watch the walk test LED for detection. See
Pattern Adjustment
if changes are required in the detection
area.
Reassemble the sensor and completely walk test again
following any lens adjustment.
To select the appropriate relay time, set the DIP switches as
shown in
DIP Switch Options
on page 4.
LED Indicator
The LED turns red for the duration of the lock relay time
when motion is detected and flashes twice per second
during the 20-second warm-up period. The LED turns yellow
when the radar detects motion. The LED turns green when
the passive infrared (PIR) detects motion.
Internal Sounder
A continuous tone will sound 15 seconds prior to the end of
the relay timer period. A beeping tone will sound at the end
of the external input (
X
) signal if the door is open.
Pattern Adjustment
The RCR-REX has both PIR and radar detection patterns
that may be adjusted independently.
PIR Detection Pattern
Figure 10 shows the passive infrared (PIR) detection pattern.
Figure 10:
PIR Detection Pattern