D
E
-A
CTIVATE
O
NE
U
SER
ACTION
RESULT
[
BYPASS
]
Accesses De-activation mode
[
3-digit user number
]
Example:
if 4-digit user code
or
if 6-digit user codes
If a valid user number is entered, LED1 on any enabled readers
will begin to flash.
Scan any card
The card information for the user entered in the previous step
will be cleared, and LED1 will stop flashing. After about 30
seconds, all the readers in the system will be updated.
NX-1700E Card Reader
7
D
ELETE
/
R
ESET
O
NE
U
SER
ACTION
RESULT
[
EXIT
]
Accesses De-activation mode
[
3-digit user number
]
Example:
if 4-digit user code
or
if 6-digit user codes
If a valid user number is entered, LED1 on any enabled readers
will begin to flash.
Scan any card
The card information for the user entered in the previous step
will be cleared, and LED1 will stop flashing. After about 30
seconds, all the readers in the system will be updated.
If an individual keeps the
card, it can still be deleted.
A
CTIVATING
/
D
E
-
ACTIVATING
/
R
ESETTING USERS
If User Number 0 is entered, the desired function will be performed on the user associated with the card scanned.
VII.
PROGRAMMING LOCATIONS
SCAN METHODS: Legacy mode is default. Alternative mode is shown below in brackets { }.
Refer to Location 242 Segment 1 on page 8, and the Glossary on page 17 for explanation.
L
OCATION
0 P
ROGRAMMING THE
S
CAN
F
UNCTIONS
(3 segments of binary data) Location 0 is used to select the particular function(s) that are activated when a card is scanned. More
than one function may be selected. If more than one function is selected, they will execute in order from function 1 to function 8.
Functions 1-6 will be performed based on the user’s authority as programmed by the [
] [
6
] function (refer to
keypad user manual).
Segment 1
Single Scan Function {Single Beep}
Program the functions that are performed when a card is scanned {one beep}.
LED1 -
"On" to send Code Entry function to the control panel.
LED2 -
"On" to activate the Armed Away mode.
LED3 -
"On" to activate the Armed Stay mode.
LED4 -
"On" to send the Disarm function to the control panel.
LED5 -
"On" to send Auxiliary Function #1 to the control panel.
LED6 -
"On" to send Auxiliary Function #2 to the control panel.
LED7 -
"On" to broadcast an X-10 function (see Location 241 for programming).
LED8 -
"On" to send a Request To Exit (RTE); and activate the onboard open collector output. (Default is “On”)
Location 243, Segment 2 must be programmed with a valid zone number for the RTE to be sent.
