Interlogix MobileView 3000, Руководство пользователя

Страница: 22 / 54

14 MobileView 3000 User Manual
IMPORTANT:
The recorder support either NTSC or PAL video standards but not both
simultaneously.
The recorder supports automatic selection of the video standard by detecting the
camera singal on video input 1.
If a camera is not connected to video input 1, the video standard must be set
manually.
Connecting the Camera(s)
Connect the power connector from the camera(s) harness into the Camera
Power Out connector on the rear panel of the MobileView 3000 DVR.
Connect the primary camera(s) video connector to the Camera Input and the
audio connector to the Audio Input on the rear panel of the MobileView 3000
DVR.
Adjust the camera(s)
After the camera is installed, connect a monitor directly to the camera and
observe the image.
Make any adjustments if necessary.
Video Inputs/Outputs Installation
Cameras and CCTV monitors must use copper center conductor/copper braid 75
Ohm video cable (e.g. RG-59, RG-6, RG-11) with BNC connectors.
To avoid impedance mismatch and undesired loss/reflections, 50 Ohm coax
cable (e.g. RG-58), or 75 ohm foil shield antenna cable and other types of coaxial
cable are not compatible.
All connected video sources must provide a 1 Vpp NTSC or PAL standard video
signal.
When converting other transmission types (twisted pair, fiber optics, radio) for the
video inputs, be sure to verify accurate receiver calibration and signal levels.
ATTENTION:
In order for the system to auto-detect the appropriate video format
(NTSC or PAL), make sure that there is a video signal on video input 1 upon
power-up.