Interlogix ATS1500A-IP-LP, Инструкция по установке и программированию

Страница: 185 / 376

Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 179
Table 25: Sensor types and reported events
Sensor
Type
Code Alarm Alarm
restore
Bypass Unby-
pass
Super-
vision
long
Super-
vision
restore
Low temp. SIA ZA ZR ZB ZU ZS ZJ
CID E152 R152 E570 R570 E381 R381
Gas SIA GA GR GB GU GS GJ
CID E151 R151 E570 R570 E381 R381
High temp. SIA KA KR KB KU KS KJ
CID E158 R158 E570 R570 E381 R381
Water SIA WA WR WB WU WS WJ
CID E154 R154 E570 R570 E381 R381
Fire SIA FA FR FB FU FT FJ
CID E110 R110 E570 R570 E373 R373
Generic SIA UA UR UB UU ZS ZJ
CID E150 R150 E570 R570 E381 R381
See also Appendix B “Advisor Advanced reporting codes” on page 327.
4.1.n.6.29 Virtual zone
1>Outputs
2 Rkp
The menu allows mapping the selected zone to an existing output or a keypad.
If an output or a keypad is not set, the zone state follows the state of the physical
input assigned.
• If an output is selected, the zone becomes a virtual zone that is active when
the selected output is active. In this case the physical input has no effect on
the zone.
• If a keypad is selected, the zone becomes a virtual zone, which is active
when the selected keypad has request to exit state (RTE) active.
See also “Outputs” on page 67.
4.1.n.6.30 Held open
30 Held open
>No<
The menu defines if this zone raises a “zone open too long” alarm while held
open longer than for a defined period.
The held open period is defined in “8.1.4.6 Held open time” on page 236.
Note: If the option is active, the option “4.1.n.6.5 Double knock” on page 174 is
not available.