12
If you installed multiple boards for multiple screens, connect a
video cable from each computer monitor to the blue video output
port on each board.
If a computer monitor has no built-in video cable, use a shielded
video cable with a 15-pin (D-sub) video connector at one end for
the video output port on the board, and the appropriate connectors
at the other end for the video input port on the computer monitor.
NOTE
Monitor input ports are usually D-sub or Bayonet Nut Connect
(BNC) connectors. Shielded cables usually have a ferrite core (a
box- or cylinder-shaped attachment) near each end to reduce
interference with radio frequencies.
3. If you want to use a stereoscopic display device, connect the
controller’s stereo sync cable to the stereo sync output port on the
board. See the previous figure.
4. Turn on the computer. The video display starts in VGA mode.
5. Install the Intense 3D Pro 2200S video display driver as instructed
in Chapter 4, “Installing the Software.”
Video Output
Stereo Sync
Output
