5
Initial operation
© 2021 Interflex Datensysteme GmbH
IF-4076-0 Access Manager
18
1. Secure the power cable with the strain relief
3
2. Strip the insulation of the wires
1
for the power supply approx. 4 cm from the strain relief and
connect them to terminals L and N as shown in the figure.
3. Secure the wires
1
with the cable tie
2
4. Strip the insulation of the wire
4
for protective earth approx. 7 cm from the strain relief and connect it
to the earth terminal.
5 Initial operation
With the appropriate accessories, the following options are available for connecting the host computer to
the controller:
n
Via WLAN with the IF-ServiceApp 75-99-0013
n
Via service interface or USB
Service interface
USB
IF-4xxx controller
75-4070-0001
service cable 4xxx (connection in housing)
IF-4070 controller
75-4070-0002
service cable 4xxx (connection via RJ45)
IF-5xxx master terminal
75-99-0006
Service cable 5xxx
5.1 Connecting the controller to the network
You can connect the controller to the network via a service cable and the serial service interface or via
WLAN with the IF-ServiceApp.
IF-ServiceApp
Prerequisites
ü
Controller is connected to the IF-ServiceApp.
Detailed information on this subject can be found in the documentation of the IF-ServiceApp.
Service interface
Accessing the controller via SSH requires the freeware PuTTY version 0.73 or higher:
1. Switching on the power supply
2. Establish serial connection between host computer and controller
3. Open PuTTY
4. Check and adjust parameters
