Setting Groups
Setting the control group allows you to independently control the power of each light in your studio without
affecting your other lights. Your Honey Badger can be set to eight different control groups (A-H). Press the
“GROUP” button to assign your light to it’s own group.
NOTE:
Setting the control group is only necessary when using Interfit remotes.
If you are using a third-party
radio or optical slave, you can skip this section. When using an Interfit TTL remote, only groups A-C are available.
Beep Button
Press the “BEEP” button to turn off the audible sound for buttons, power adjustments and refresh notifications.
NOTE: When using an Interfit remote, the beep will sound if you attempt to lower the power below 4.0,
regardless of whether the beep function has been turned off.
Optical Slave Cell
When using a multiple-light setup with your Honey Badger and a sync cord or a third-party remote, turn on the
“CELL” button to activate the optical slave function. This will allow the light to be triggered by the light of your
other flashes.
NOTE: The optical slave cell requires direct line of sight between lights.
Mounting to a Light Stand
Your Honey Badger 320 will mount to most standard light stands with a 5/8” stud. Unscrew the Stand Mount
Tightening Knob until the mount fits onto the light stand. Make sure to turn the Mount Knob until tight.
Use the Ratcheting Adjustment handle to adjust the angle of the light on the stand. The resistance of the
Ratcheting Adjustment handle provides extra security when using large, heavy modifiers.
Interfit 24” (60cm) Pop-Up Softbox
Take your softbox out of it’s zipper pouch and carefully let it spring open. Attach the hooks of the inner diffuser
to the elastic loops on the inside of the softbox. Attach the outer diffuser to the Velcro around the outside of the
softbox.
Mounting: Opening of softbox will fit tight around the outside of the mount ring. Take turns atretching each side
over the mount ring and the softbox will stay attached by tension.
Replacing the Flash Tube and Frosted Glass Dome
Both the flash tube and frosted glass dome are user-
replaceable. Replacement parts can be purchased direct
from Interfit Photographic or a certified Interfit dealer.
*The oil from your fingers will damage flash tubes.
Be sure to handle new flash tubes with gloves or clean
cloth. Always use caution when handling broken glass.
www.interfitphotographic.com 7
BEEP
CELL
GROUP
