28
ADVANCED SETUP GUIDE
The suggested settings below can help you optimise the QED for the type of detecting you are doing at the
time, including setup for different target size, ground conditions, EMI, etc.
For example, if you are after small gold using a small coil or if you are looking for any gold or looking just for
larger targets using a large coil.
Step
Small Coil
Medium/Large Coil
Turn the detector
ON
Mode
1
–
8
•
dependent on ground
conditions but as low as
possible
8
–
15
•
dependent on ground
conditions but as low as
possible
Ground Balance
•
MGB, or
•
AGB
THS B
•
Neutral for all targets
•
lower than Neutral to enhance
small target response
•
Neutral for all targets
•
Higher than neutral to enhance
large target response
THS A
Low (~30 or less)
Start at Default (30) and increase to
achieve desired threshold
GAIN
As high as prevailing EMI conditions and Ground Type allow
PITCH
Adjust to preferred signal response.
SMR
Default
(107)
Adjust
SMR
to null out external EMI interference if detected.
Note: The Default value of 107 should work in most
instances and only change if non-random rhythmic
EMI is present.
SMF
Default (50)
Re-Ground Balance
•
MGB, or
•
AGB
Notes
Tip:
Once you have adjusted the detector to suit, leave the detector in the MGB adjustment setting so that
you can quickly adjust the GB whilst you are detecting.
Содержание QED-PL2
Страница 18: ...18 2 THRESHOLD B THS B BIAS Setting range 1 99 Factory preset at 50 Notes ...
Страница 34: ...34 NOTES ...
Страница 35: ...35 ...
