Interalia XMU+, Руководство по установке

Страница: 25 / 63

Caution...
Forcing the T1
line card into
place could
bend the pins on
the connector.
XMU+ Installation Handbook rev.06
19
Applying T1 Line Card Settings
3. Pull the T1 line card straight out.
Locate the secondary option switch on the side of the T1 line card, as shown
below:
Secondary Option Switch
4. Set the secondary option switch on the side of the T1 line card to the
appropriate protocol, as defined by the following table.
T1 Protocol Selector...
Reserved 0 0 0 0 0 0 0 1
Loop Start (FXS) D4 * 0 0 0 0 0 0 1 0
Loop Start (FXS) ESF 0 0 0 0 0 0 1 1
Clear Channel D4 0 0 0 0 0 1 0 1
Clear Channel ESF 0 0 0 0 0 1 1 0
Note:
* = default factory setting
Closed = 0, Open = 1
5.
Line up the line card’s circuit board on the plastic rails in the chassis.
6.
Slide the line card into place. When seating the line card, there should be slight
resistance. Do
not force the line card into place.
7.
Tighten the thumbscrews.
8.
Repeat Steps 1 to 8 if another T1 line card is to be installed in the XMU+.