3. Installation
—
Scape®
Movable
Technical specifications are subject
smo55-005
to change without notice.
Operating Manual
Version 1.6 – Status: 12/2019
Page 15 of 33
poc: SFi
3.
Installation
The
Scape® Movable
is delivered ready for operation. All units are fully assembled and wired.
Place the device in a suitable location and connect it to the power supply.
3.1.
Notes
Observe the following points when setting up the device
:
·
Give the
Scape® Movable
sufficient time to adapt to the ambient temperature. Otherwise the device may be damaged
or destroyed by condensation inside the device.
·
Only operate the
Scape® Movable
indoors.
·
Do not expose the
Scape® Movable
to direct sunlight.
·
Make sure that there is enough space around the
Scape® Movable
to move the lift frame.
·
Before operating your
Scape® Movable
, remove the white or red plastic protection on the rollers of the lift frame. To
do this, pull the white tab in the middle of each roller firmly. Note that the lift frame has 8 castors.
3.2.
Connection to the power supply
Connect the
Scape® Movable
to the mains using the supplied IEC power cord via the power connection socket at the
base of the device (see
Chapter 2.2.1 – Lift frame – item 1
).
To do this, first plug the IEC plug into the corresponding socket on the device and then the earthed plug into the mains
socket.
When disconnecting the appliance from the mains, always pull the plug and do not pull the cable.
Do not touch the plug with wet hands.
3.3.
Connection to the network
The
Scape® Movable
works completely without an internet or other network connection. However, both WLAN and the
Gigabit Ethernet port on the integrated PC (see
Chapter 2.2.3 – Integrated PC – item 9
) can be connected to the
internet or another network.
To use Capore® object recognition or touch via TUIO, set the switch for the touch signal on the back of the display to
"TUIO" (see
Chapter 2.2.4 – Touch screen – item 2
). For further information on setting up
Capore®
Touch & Object
recognition, refer to the operating manual for the "
Capore® Touch & Object Assistant
".
The default IP address of the integrated
Capore® API Box
is 10.0.0.20, subnet 255.255.255.0. You can access the web
interface of the
Capore® API Box
via that IP address. The Ethernet port of the
Scape® Movable
(see
Chapter 2.2.3 –
Integrated PC – item 9
) is set to obtain its IP address from a DHCP server.
Содержание Scape Movable smo55-005
Страница 1: ...Scape Movable smo55 005 Operating Manual ...
