B
G
3X
U
W
E
2X
AB
Flange
Grid
F
H
90
H
DRAWING NOT TO SCALE
5B: Magnetic Surface Mounting.
If magnet
mounting was specified, fasten provided
magnets, evenly spaced, to backside of
luminaire (B).
Step 5; Installation of Mounting Hardware:
There are four methods to install the luminaire with
different mounting hardware. These methods are shown below. Proceed with the method
specified for this project.
Intended Mounting
Surface
Step 8; Prepare Ceiling: Drill adequate sized
power feed cable hole
on ceiling which aligns
with cable of Luminaire (B). Pull the low voltage
cables of remote driver through the hole, and
make electrical connection to Luminaire (B).
Push Luminaire (B) on Screw Clips (E) until it
properly snaps into position. Finally, power and
test the fixture for proper
operation.
940-SM20LDL
5A: Screw Clip Mounting.
If screw clips mounting
was specified, fasten provided clips, evenly
spaced, to intended mounting surface (see
below).
5C: Grid Ceiling Mounting.
If grid ceiling
mounting was specified, push grid clips, evenly
spaced, onto grid at an angle, then twist to
lock in place.
5D: Mounting with Bracket.
If adjustable
brackets were specified, bend the brackets 90
degrees, then, with even spacing, screw the
brackets onto the intended mounting surface.
410-381-1497 inter-lux.com
PAGE 3 OF 5
*Inter-lux reserves the right to make changes to this product and related installation instructions at any time without prior notice.
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF
Inter-lux
. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF
Inter-lux
IS PROHIBITED.
PROPRIETARY AND CONFIDENTIAL
WG-SM20LDL
INSTALLATION INSTRUCTIONS
Whitegoods 20 Linear Surface
CAUTION: CAUTION:
THIS IS AN ELECTRONIC DEVICE. CARE MUST BE TAKEN INTER-LUX IS NOT RESPONSIBLE FOR THE
DURING STORAGE AND HANDLING. STORE IN A CLEAN, COOL STRUCTURAL INTEGRITY OF THE BUILDING TO
AND DRY LOCATION. ELECTROSTATIC DISCHARGE (ESD) CAN SUPPORT THE LUMINAIRE. ADDITIONAL BACKING
HARM THIS PRODUCT. AVOID STATIC DISCHARGE WHILE MAY BE REQUIRED.
HANDLING THIS PRODUCT.
WARNING:
WARNING:
WARNING:
INSTALL PRODUCT IN ACCORDANCE
FAILURE TO COMPLY WITH THE
READ ALL SAFETY INSTRUCTIONS
WITH LOCAL AND NATIONAL ELECTRICAL
INSTALLATION INSTRUCTIONS MAY
INCLUDED WITH LUMINAIRE BEFORE
CODES BY A QUALIFIED ELECTRICIAN.
RESULT IN DEATH OR SERIOUS INJURY.
INSTALLING LUMINAIRE. SAVE
INSTRUCTIONS FOR FUTURE USE.