2
Retrofit_Table-IM Rev. 5/15
I N S T A L L A T I O N M A N U A L
R E T R O F I T T A B L E S
ASSEMBLY & INSTALLATION INSTRUCTIONS FOR TABLES:
1. Locate the support pole receiver. NOTE: white internal ring end gets glued into table flange. See Figure 2.
2. Place the support pole receiver on top of the support pole. NOTE: the support pole will help facilitate
the gluing of the support pole receiver into the table flange. See Figure 3.
3. Lay the table upside down on the cardboard box to prevent scratching. Use PVC glue (not included) to
permanently attach the support pole receiver to the table flange. Use the support pole to fully seat the
receiver into the flange. See Figure 4 and Figure 5.
4. When the receiver is fully inside the flange, the support pole can then be removed. See Figure 6.
5. An umbrella (not included) may be used by removing the clear cap from the table grommet. (Maximum
umbrella pole size is 1-5/8” or 1.625”).
6. Install the 1.50” adapter into existing deck anchor. Slide support pole over 1.50” adapter and set table on
support pole.
7. When removing the table be sure to remove the 1.50” adapter.
NOTE:
If a shorter table height is desired, determine height required, cut the support pole with a hacksaw
and deburr.
Figure 2: Pole Receiver
Figure 3: Pole Receiver on Support Pole
Figure 4: Pole Receiver Shown with Table Flange
Figure 5: Pole Receiver Attached to Table Flange
Figure 6: Properly Glued Pole Receiver Shown
