Intellitec ST410, Инструкция

Страница: 6 / 28

XB410 ST410
Length 415mm 415mm
Width 255mm 328mm
Height 142mm 156mm
Wheel base 275/280mm 290/295mm
Drive 4WD 4WD
Specifications
XB410 Brushed XB410 Brushless ST410 Brushed ST410 Brushless
Motor 550 3000kV 550 3000kV
ESC 40A (max 2-cell LiPo) 45A (2-3 cell LiPo) 40A (max 2-cell LiPo) 45A (2-3 cell LiPo)
Battery 1800mAh NiMH 3000mAh NiMH 1800mAh NiMH 3000mAh NiMH
Gear ratio 8.3:1 8.3:1 8.3:1 8.3:1
Features
· 2,4GHz radio
· Water protected ESC, RX & servo
· Front CVD
· Metal diff
· Aluminum motor mount
· 4WD with drive shaft
· Ball-bearings on crucial points
· Slipper clutch
· LiPo ready
· NiMH battery & charger included
· Option and upgrade KIT available
Recommended tools
These tools are not included with the product but are
recommended for use while working on the model:
scissors, mini screwdrivers, hexagonal screwdrivers
1.5mm, 2.0mm, 2.5mm, 3.0mm, 4-way cross wrench
(small), 4-way cross wrench (large), side cutters, needle
nose pliers.
Driving a radio controlled car - important information
To get the maximum fun of your radio controlled model, there are a few things that are important to remember.
The model you bought is not a toy but an advanced model with high performance. Always start by going through the
manuals supplied with the model and familiarize yourself with the model’s various parts. If you are unsure about any
moment, please contact the store where you purchased the model.
Charging the batteries
Batteries that are charging may not be left unattended. If the batteries gets warm during charging, the process
must be aborted.
Before driving
Find a suitable area where you can use your model. The area should be free of fixed objects and obstacles that could
damage the model. Check that the batteries for the transmitter is new / charged and that the batteries in the model
are fixed and can not come loose. Never drive towards any bystanders or animals. If it is wet check that your model can
handle moisture / water. Makes a range test before you start using your model.
Starting up
A) Always turn on the power to the transmitter first. B) Then add the battery and ESC. C) Turn on the ESC
D) Check the steering, throttle and brake. E) Now you are ready to run your model. When shutting down, do the opera-
tions in the reverse order.
After driving
Clean the model and check for any loose screws. It may be enough that one screw comes loose on your model to
cause an accident. It is important that you charge the battery after driving. This is especially important when using LiPo
batteries. Storing a battery completely discharged may damage it. Always disconnect the battery from the model after
driving.
EN