Intellipet ZW18900-05, Быстрый старт

Страница: 9 / 16

9
1. Splicing to the boundary wire.
Pull the twisted wire to the perimeter location of the two
ends of your boundary wire loop. Splice the ends of the
twisted wire to the ends of the boundary wire with the
supplied waterproof splices. Use only waterproof splices
supplied with this system. Use of wire nuts alone, elec-
trical tape or solder will not provide a waterproof and
secure connection for your system to function properly.
To use the gel-filled capsule
splice, strip 5/8” of insulation
from the wire ends. Insert ends of
wire into nut and twist to secure.
Insert the wire nut as deeply as
possible into the waterproof gel
and snap the lid shut. Tie a knot
in the wires as shown to avoid
having the wires pulled free dur-
ing installation.
2. Bring outside wire to transmitter
From the outside, push the twisted pair of wires through
the hole in the wall. Strip about 5/8” of insulation from
the two ends. Insert ends into loop wire terminals
marked on the transmitter (one in each terminal).
3. Plug transmitter in
Use supplied adapter and plug transmitter in.
Turn transmitter knob to on position.
The red light should illuminate on your transmitter indi-
cating a properly installed boundary loop. If the light
does not come on, refer to the Training and
Troubleshooting Guide.
1. Install batteries.
Unscrew collar battery cap turning counter clockwise.
Insert battery with the + facing out toward the battery
cap. Carefully screw battery cap on and ensure it is
seated straight.
Gel-filled
capsule
Wire
Step 4
Final connections
Step 5
Power up