3
hardware iNStallatioN
To install a hard disk/drive in the Gigabit SATA NAS 2TB, follow the
steps below.
1. Shut down the NAS and unplug the power cord from the AC outlet.
2. Remove the screws that secure the hard
disk/drive cover to the side of the NAS
device and slide the cover off.
3. Slide the hard drive/disk inside the
cover you just removed from the NAS
device.
4. Connect the SATA cable and hard
disk/drive power cord between the
hard disk/drive and the NAS.
5. Re-position the HDD/cover assembly onto
the NAS, being careful not to crush (and
possibly damage or disconnect) the SATA
cable and HDD power cord. The hard
disk/drive installation is now complete. Turn
on the NAS.
