OVERVIEW
Switched Mult 1U is an expandable, dual-bus, 6-jack passive signal multiplier, with a 3-position
switch to facilitate asymmetrical routings — enabling each jack to be a mult of the
X
bus; a mult of
the
Y
bus; or to be turned off entirely.
A signal multiplier accepts an input signal and routes it to multiple outputs simultaneously. For
example, you might want a sequencer’s GATE to trigger two different envelopes — one to control
volume and one to control filter frequency. In order to accomplish this, you need a signal multiplier.
In addition, each Switched Mult 1U features a pair of 3-pin Link connectors on the rear panel. These
let you connect other 3-pin Link devices, such as an
XY I/O 1U
module, or even additional
Switched Mult 1U
modules (handy for distributing mults across the width of your case).
FRONT PANEL
[1]
Jacks
: Each of these six unbuffered jacks
can be assigned to either the
X
bus; the
Y
bus; or switched
off
entirely, using the
corresponding
Bus Switches
[2]
.
Plug an audio or CV signal into one jack, and
an unbuffered version of it will appear at
every other jack that has its
Bus Switch
[2]
set to the same position.
[2]
Bus Switches
: Each
jack
[1]
has a
dedicated 3-position Bus Switch:
●
X
Bus (top) : When a switch is in the up
position, its corresponding jack accesses the X bus multiplier.
●
Y
Bus (top) : When a switch is in the down position, its corresponding jack accesses the
Y bus multiplier.
●
OFF
(middle) : When a switch is in the middle position, it is disabled and not connected to
either bus.
Switched Mult 1U Manual
4
