Audio Interface II Manual
Controls
1. INPUT GAIN L/R
These knobs set the gain of the signal coming in to the modular via the
BAL IN L/R
jacks. The knob range is from -∞ (no signal) to +6 dB. The signal levels are indicated on
the meters above the
OUT L/R
jacks.
2. OUTPUT GAIN L/R
These knobs set the gain of the signal leaving the modular via the
BAL OUT L/R
jacks.
The knob range is from -∞ (no signal) to +6 dB. The signal levels are indicated on the
meters above the
IN L/R
jacks.
Inputs & Outputs
A. OUT L/R
These jacks are the modular level outputs of the signals that come into the system via
the corresponding channel of the
BAL IN L/R
jacks. The signals are boosted to modular
levels according to the
INPUT GAIN
knobs.
B. BAL IN L/R
These jacks bring signals into your modular system from the outside world where they
are accessed from the corresponding
OUT L/R
jacks. Connect a 1/4″ balanced TRS
cable from the output of your other synthesizers, effects pedals, audio interfaces, etc. to
these jacks.
C. IN L/R
These jacks are the modular level inputs that send your modular’s audio to the outside
world. A modular audio signal connected to these jacks will appear at line level on the
corresponding
BAL OUT
jacks, with gain controlled by the
OUTPUT GAIN
knobs.
D. BAL OUT L/R
These jacks carry signals from your modular to your other audio equipment. Use a 1/4″
balanced TRS cable to connect each one to an input of an effects pedal, audio interface,
tape recorder, etc.
Page 7
