Intelligent Glass Switchable Film, Руководство по установке

Страница: 8 / 11

8
‘© Copyright Pro Display 2009’
Step 11
Use the soft edge squeegee to work any small bubbles and the edges of the film. Please note that if any edges
are lifting slightly these will relax down once the protective liner is removed.
Step 12
Once the film is installed on the glass you can then start work on wiring the bus-bar. Carefully solder the
electrical cable to the mesh tags. There are two tags on the left hand side and two tags on the right hand side.
Solder a cable to one tag on the left (positive connection) and one tag on the right (negative connection).
The other tags are only there as spares. At this stage it would be good to connect the cables to a switch /
transformer and test the switching from frosted to clear. Once you have tested the switching you can them
trim off the spare mesh tags.