10
Factory Default
8.0 Performing a Factory Default
FIRST:
Please remove the back lock body cover
NEXT: Disconnect the power cable from the battery pack.
NOTE: If you are trying to troubleshoot an issue with the 1Touch,
reconnect the power cable and test your lock. If the lock now works, the
problem was likely a cable connection issue. If this does not solve the
problem, disconnect the power cable and move on to the next steps.
NEXT: Remove the front lock body off the door.
NEXT: Remove the back lock body off the door.
NOTE: It is recommended to use new AA batteries. If available, connect a
9VDC battery instead of the battery pack for added power during Reset.
NEXT: Reconnect the front & back lock bodies by reconnecting the power
cable to the battery pack or a 9V battery.
NEXT: Find the “Reset” button on the back of the front lock body.
NEXT: Press & hold down the small button labeled “Reset”.
NEXT: While holding the “Reset” button down, use your other hand to
slide the scanner cover up.
NOTE: After about 10-15 seconds you will hear a single beep indicating
the lock has been reset.
HINT: To confirm, slide the cover up & enter the default Master Code
11111111. It will open the lock.
For more troubleshooting information visit:
http://www.fingerprintdoorlocks.com/help/
6) If you are hearing a Beep sound:
1-Beep = Successful Action (scanned finger, entered code etc..)
3-Beeps = Unsuccessful Action
3-Sets of 2 Beeps = The User ID# is already in use
Rapid beeping sound when the cover is lifted = Low Battery Warning
Rapid beeping sound when enrolling a new user = Out of Memory
1Touch
®
evo3 Series Fingerprint Lock
http://www.1touchlock.com | Intelligent Biometric Controls, Inc. | v1.1
