2
Pa
ge
2
Super fast setup (Getting the camera operational
–
for semi-experts)
If you are very familiar with the concept of IP addresses and IP cameras and would like to proceed as quickly as
possible to see live and recorded video with wireless and remote operation:
(Before you permanently mount the Camera go through this pre-configuration step.)
1) Connect the included power supply to power and to the camera, and connect the included network cable to
your router and the camera.
2) Find the camera’s IP address in your router’s attached device list
(DHCP list) and then reserve the IP address so that it doesn’t change, unless you have an Apple Airport, in
which case you would use Airport Utility to reserve an IP address such as 10.0.1.2 based on the camera’s
MAC
address (printed on the tag on the cable or sticker on the back)
3) Type http:// and your camera’s IP address into a browser, click on
“Enter” and log in with username:
admin
, password:
admin
, and if you
are using Internet Explorer on a PC, allow both ActiveX installations
At this point you should already see nice video from the camera!
4) At the top of the camera screen select
“
Setting
” then click on “
Task
” then select the
“
Task Management
”
menu, place a
checkmark on task #9 and
“
Apply
” to
start
motion detection recording. Briefly walk or
wave your hand in front of the camera, then
wait 2 minutes for recording of the first file to
complete.
5) For Wireless Setup: attach the antenna.
Then in the Settings tab, click on “
Network
” then select “
Wireless Setup
”. enable wireless, and scan for
available network by selecting “
Search
” to find your network
, select it
and “
Apply
”, type and re
-type your
password and “
Apply
” again to save it, then “
Test
” to confirm that you have no typo, and disconnect the cable.
At this point your camera should work wirelessly!
Click on “
Storage
”
then click on the
“
Browse Storage
” menu
.
At this point you should have your first recorded video!
