2
INTRODUCTION:
The RX-440 is a wireless receiver/processor which allows the User to trigger
various devices using Intellicam’s wireless sensor platform.
FUNCTIONS:
This programmable module provides the following functions:
•
Relay Contact Closure: Time is programmable from 10 to 240
seconds. 1 Amp max.
WIRING DIAGRAM:
The following wiring diagram is the Canon connector pin configuration.
Contact Closure uses the
Relay ‘D’ Red Wire
and
Relay ‘A’ White Wire
.
SET UP AND OPERATION:
To use the device, install 4
“AA” batteries in the battery holder. The
RED
LED
on top will briefly illuminate. If no
“runtime”
programming is
performed, the Dry Contact will only close briefly (approx. 1-2 seconds).
PROGRAMMING:
To program the RX-440:
1.
Press and hold the
PROGRAMMING BUTTON
until the
RED
LED
illuminates.
2.
Immediately release upo
n illumination and “tap”
the
Programming Button for the number of times corresponding to
the desired Run Time. (One press equals 10 seconds.) Example,
if you want 30 seconds of Contact Closure, press the button 3
times. The
RED LED
will confirm the programmed Run Time by
flashing 3 times.
3.
Once triggered by a sensor, the RX-440
RED LED
will remain
illuminated for that programmed Run Time of 30 seconds.
4.
NOTE:
After the first 10 minutes, the RX-440
RED LED
will
automatically turn “off” for covert purposes
, and no longer
illuminate.
Ground (B)
Black Wire
Serial Data(C)
Green Wire
Relay (A)
White Wire
Relay (D)
Red Wire
