DocRef#0460601
CNS-4G - User Guide
Page 7
Chapter 5
–
Programming & Configuration
All programming and configuration should be performed at your office, before deploying
in the field.
During configuration you should use the AC Adapter plug to power the Gateway, rather
than using battery power which might shorten the battery life of your CNS-4G.
Power up the Gateway (use AC Adapter and Wi-Fi Antenna Figure 6). Leave all other
cables plugged in. Connect your laptop or Wi-Fi enabled phone to the
Gateway’s
Wi-Fi
hotspot named
“Bivocom
_****
”.
The pass
word to the “Bivocom” Wi
-Fi hotspot is
“admin123”.
Next, open your browser and enter the IP Address to 192.168.1.1. Once
the configuration page has opened, enter the User Name of
“admin” and the Password is
“admin”.
The configuration page will look like Figure 5.
Option: You may also connect through an Ethernet cable by configuring your local IP to
192.168.1.100, then opening your browser to 192.168.1.1. If you use this option, it is
highly recommended that you change the logon p
assword from “admin” immediately.
Figure 5
Figure 6
