48
Operating Install Wizard
ü
Step 8: Line-up Test
Perform a line-up test by the satellite operator to confirm antenna performance and operation status.
(Option 1: Using iDirect Open AMIP Modem)
Description
1. Check modem status for connection
readiness by clicking the "
Check
Modem Status
" button. Then
connect to iDirect Open AMIP
modem by clicking the "
CLI
Connect
" button.
2. Enter the "
RF Uplink Frequency
"
received from the satellite
operator through communication
and click the "
Apply
" button.
This menu can be edited when the
antenna is connected to iDirect Open
AMIP modem and the CW is off.
3. Adjust the "
Transmit Power
" of
the frequency using the arrow keys
which increases or decreases by
0.5dBm.
4. Adjust the "
Antenna Angle
".
5. Enter the "
Test Result
" value
received from the satellite operator
and click the "
Apply
" button.
If you have no problems, click the
"Next" button.
1
2
3
5
NOTE
NOTE. A
The "Cable Compensation Range" is determined by the condition of installation (Modem, BUC). There
exist four cases of cable compensation as follows.
Case Modem*
BUC M&C**
Compensation Method
Compensation path
1
iDirect
O
IF signal Source:
iDirect
Output Power monitor:
BUC M&C
Full path Calibration
2
iDirect
X
IF signal Source:
iDirect
Output Power monitor:
Stacker
Exclude calibration:
BUC
3
iDirect
O
IF signal Source:
De-stacker
Output Power monitor:
BUC M&C
Exclude calibration:
Modem to ACU Cable
4
Not use
iDirect
X
IF signal Source:
De-stacker
Output Power monitor:
Stacker
Exclude calibration:
Modem to ACU Cable, BUC
*Modem: iDirect X5, X7 Series which are able to access Telnet and support CLI.
**BUC: NJRC, Terrasat products which have M&C function.
NOTE. B
The "Attenuator Graph" displays attenuator values corresponding to the frequency.
• Frequency Range: 950 ~ 1700 MHz(@ 50 MHz step)
• Attenuator Range: 0 ~ 31.5 dB
