Installation
To install the Intelix DIGI-HDMI-HR-R baluns, perform the following steps:
1.
Turn off power and disconnect the audio/video equipment by following the
manufacturer’s instructions.
2.
Make certain that outlets and cross connects to which you will connect the DIGI-
HDMI-HR-R are configured properly and labeled correctly to identify the point-to-
point circuit.
3.
Verify the desired twisted pairs are not being used for other LAN or telephony
equipment.
4.
Verify that the source and destination equipment work when directly connected with
an HDMI cable. Be sure to test both HDMI cables required for system installation.
5.
Connect the DIGI-HDMI-HR-R receive balun to the HDMI input of the receiving
device at the remote end. Do
not
connect the 5V power supply.
6.
Connect the opposite ends of the twisted pair cables to a compatible Intelix HDMI
twisted pair matrix. Ensure the cable conforms to EIA 568B crimp standards and
there are no split pairs or taps.
7.
Connect the 5V power supply to the DIGI-HDMI-HR-R receive balun.
8.
Power-on the video equipment.
9.
Verify picture quality.
Caution:
Do not attempt to disassemble or alter the balun housing. There are no
user-serviceable parts inside the unit. Doing so will void your warranty.
Caution:
Do not connect the balun to a telecommunication outlet wired to
unrelated equipment. Doing so may damage the unit or any connected equipment.
Ensure all connected twisted pair cabling is straight-through (point-to-point).
Caution:
To minimize the possibility of equipment damage from electrostatic
discharge (ESD), all source and destination equipment must be powered off during
installation. This includes signal extenders, splitters, and switches.
Note:
For your convenience, it is recommended that you uniquely mark the ends
of the twisted pair cable before pulling them through a wall or conduit.
