Installation
1.
Power
off
the
source
and
destination
devices
which
will
be
connected
to
the
extenders.
2.
Verify
the
modular
outlets
and
cross
connects
to
which
you
will
connect
the
AVO
‐
USB
are
configured
properly
and
labeled
appropriately
to
identify
the
circuit.
3.
Verify
the
desired
twisted
pairs
are
not
being
used
for
other
LAN
or
telephone
equipment.
4.
Connect
the
AVO
‐
USB
‐
H
to
the
USB
port
of
the
host
device,
typically
a
computer.
5.
Connect
one
end
of
the
twisted
pair
cable
to
the
send
extender.
The
RJ45
pinout
in
the
twisted
pair
cabling
should
conform
to
the
EIA/TIA
568A
or
568B
standard.
6.
Connect
a
compatible
transmitter
to
the
client
device,
typically
a
keyboard
or
mouse.
7.
Connect
the
other
end
of
the
twisted
pair
cable
to
the
receive
extender.
The
RJ45
pinout
in
the
twisted
pair
cabling
should
conform
to
the
EIA/TIA
568A
or
568B
standard.
8.
Power
on
the
source
and
destination
equipment.
Caution:
Do not connect the extender to a telecommunication outlet wired
to unrelated equipment. Doing so may damage the unit or any connected
equipment. Ensure all connected twisted pair cabling is straight-through
(point-to-point
).
Caution:
To minimize the possibility of equipment damage from
electrostatic discharge (ESD), all source and destination equipment must
be powered off during installation. This includes signal extenders, splitters,
and switches.
Note:
For your convenience, it is recommended that you uniquely mark
the ends of the twisted pair cable before pulling them through a wall or
Note:
The AVO-USB supports speeds up to 12 Mbps. Distance is
dependent on transmission speeds. Please refer to the technical
specifications for maximum distances.
