INTELCO ELECTRONICS
4
ISO9001/2015
Rev. 1.01 March 2016
Quick-Start Setup:
In order to startup the GSM Gateway device, please power up the device and then
short RESET pins by placing the RESET jumper. At startup of the device one short
buzz sound.
Device makes a quick check on AC power supply. If there is no AC power, device
will start up, powered from Battery if connected and it is good charged. While de-
vice performs the action above all onboard leds are keep blinking every 500 ms .
After 4-5 sec device will start seeking for network to connect according to provider
of the applied SIM card and while this action S1,S2 and S3 leds are blinking and
Network led is blinking every 500 ms indicating that no network found till now. If
Network can not be found in a specific period of time, device timeout the process.
If Network did not found, device will work with
“NO SIM Card detect”
and can only
make outgoings call to (112) . If Network is approached device will work with
“SIM
Card detect”
and fully functional.
When S1,S2 and S3 leds stop blinking and Network led blink every 3 seconds then
onboard buzzer will buzz 2 times with short pause between.
Double buzzing sound let the user know that the startup process is just finished and
device is READY FOR USE, with every feature available to the user according the
status of network connection.
Functions with
“SIM Card detected”
:
Voice Ready
SMS Ready
Data Ready (Not Available)
Battery check
Functions with
“SIM Card not detected”
:
Limited Voice Ready ( International Emergency Number (112))
Battery check
STEP 1
STEP 2
STEP 3
STEP 4