Intelbras IVP 9000 MW MASK, Руководство пользователя

Страница: 8 / 21

8
4. Installation
» Before starting the installation, it is necessary to define the height at which the sensor will be positioned, which can
vary from 2 to 2.4 m;
» Do not install sensors that have microwave technology close to each other, as there may be interference between them;
» The microwave sensitivity adjustment must be done according to each environment;
» For installation using the articulator, make sure that both the sensor and the bracket are securely fixed in the installation
location to avoid changes in the product’s detection angle. Incorrect use of the articulator can change the sensor’s de-
tection area, creating blind spots and impairing operating efficiency;
» If the sensor is installed at an angle, its detection range and PET function may be impaired in such a way as to nullify
the function.
To install the sensor, follow the procedure below:
1. Unlock the back cover by partially loosening the screw and remove it by sliding the front cover down, as shown in the
picture.
2. Route the wiring through the cable passages located on the sensor back cover.
Note:
use a tool to drill the hole in the indicated location.
Cable passage