Care and safety
» Install the sensor in a stable location that is not subject to flickering.
» Install the transmitter and receiver so that they are aligned;
» LGPD - General Law for the Protection of Personal Data: Intelbras does not access, transfer, capture, or perform any other
type of treatment of personal data from this product.
» Do not install the sensor in locations where beam obstruction may occur. Check that there are no plants, branches or
other objects that could obstruct the sensor beam;
» Do not install the receiver and transmitter with the lens facing the sun;
X
X
X
X
» Make sure that the cable input side faces down to prevent water from entering;
» Size the power supply and power cord correctly;
» Do not leave the cable exposed to the sun, rain or moisture;
» Do not install the sensor above the recommended distance;
» Always check that there are no reflections on clear and polished surfaces, which can prevent the sensor from triggering.
Do walking tests in different positions along the barrier to make sure there are no reflections;
» Use the sealing rubber correctly to prevent insects from entering the sensor;
» To clean the outside of the sensor, use a cloth moistened with water; never use chemicals.
» For installation of stacked sensors, the maximum number of sensors installed is 2 (two) and they must be in different
frequency channels, as shown in the image below. If a larger coverage area is required, use sensors with more beams;
» Avoid installing the receiver near sources of electromagnetic noise. After installation, perform tests to verify the correct
functioning of the product. In case of interference, exchange the Transmitter with the Receiver;
TX
Channel B
RX
Channel B
TX
Channel A
RX
Channel A
X
TX
Channel B
TX
Channel A
RX
Channel A
TX
Channel A
RX
Channel B
RX
Channel A
