Intel SRCZCRX, Руководство пользователя по оборудованию

Страница: 18 / 29

Intel RAID Controller SRCZCRX 18
Chapter 2
Hardware Installation
This chapter describes the procedures for installing the Intel RAID Controller SRCZCRX. It
contains the following sections:
•
Section 2.1, “Requirements,” page 18
•
Section 2.2, “Quick Installation,” page 18
•
Section 2.3, “Detailed Installation,” page 19
•
Section 2.4, “After You Have Installed the Storage Adapter,” page 22
2.1 Requirements
The following items are required to install the RAID controller:
•
An Intel RAID Controller SRCZCRX
•
A host computer with the following:
–
Server board with interrupt routing circuitry (INT) routing
– 64-bit, MROMB-enabled PCI expansion slot
Note: Refer to the Tested Hardware and Operating System List to see which server
boards are supported.
•
The Resource CD
Intel strongly recommends using an uninterruptible power supply (UPS).
2.2 Quick Installation
The following steps are for for experienced computer users/installers. Section 2.3, “Detailed
Installation”, contains detailed steps.
Note: All work must be performed at an ESD-safe workstation that meets the
requirements of EIA-625: Requirements for Handling Electrostatic Discharge
Sensitive Devices. All actions must be done following the latest revision of the
IPC-A-610 for ESD recommended practices.
1) (Optional, required to enable Write Back Cache) Attach the Battery Backup Unit to the
RAID adapter.
2) (Optional, required for some chassis) Replace the bracket on the RAID adapter with the
low-profile bracket.
3) Power off the server and all hard disk drives, enclosures, and system components.
Remove the power cord from the server.
4) Follow the instructions in the host system documentation to open the cabinet of the host
system.
5) Check the jumper settings on the RAID adapter.