Intel SR2600UR - Server System - 0 MB RAM, Руководство по обслуживанию

Страница: 74 / 234

54 Intel
®
Server System SR2600UR/SR2625UR Service Guide
10. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.
Installing and Removing a PCI Add-in Card
The following sections describe how to install and remove a PCI add-in card.
Installing a PCI Add-in Card
To install a PCI add-in card, follow these steps:
1. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” on page 50 .
2. Open the rear retention clip by pushing the blue slide upward and rotating clip to
the fully open position (see letter “A” in Figure 36 ).
3. Open the front retention clip by pushing the blue latch in the direction shown and
rotating 90 degrees outward (see letter “B” in Figure 36 ).
4. Remove the filler panel from the selected add-in card slot (see letter “C” in
Figure 36 ).
5. Insert add-in card until it seats in riser card connector (see letter “D” in Figure 36 ).
Figure 36. Installing a Full-height Add-In Card
6. Close the rear retention clip. Push the blue slide upward and press the clip to lock it
into place.
7. Close the front retention clip and push the blue latch forward to lock it into place.
Note: Make sure that all empty add-in card slots have filler panels installed.
REMOVE
Filler Panel
B
A
C
D
AF002969