Intel® Server System S9200WK Product Family Setup and Service Guide
49
4.10
Memory (DIMM) Replacement
This section documents the procedure to follow when replacement of a faulty DIMM is necessary. The DIMM
replacement procedure for a liquid cooled compute module and an air cooled cooled compute module is
different. Refer to the appropriate sub-section for your specific compute module configuration.
For memory population rules, refer to Appendix B.
4.10.1
Air Cooled Compute Module DIMM Replacement
1.
Remove the select compute module from the server chassis (see Section 4.2.1)
2.
Remove the air duct from the computer module (see Section 4.8.1).
4.10.1.1
DIMM Removal
Figure 50. Removing the DIMM in an air cooled system
3.
Identify and locate the faulty DIMM. Ensure that the ejection tabs of adjacent DIMM slots are closed.
4.
Open the DIMM ejection tabs at both ends of the selected DIMM slot (see Letter A). The DIMM will
slightly lift up from the slot.
5.
Holding the DIMM by its edges, lift it away from the slot (see Letter B).
4.10.1.2
DIMM Installation
Figure 51. Installing the DIMM in an air cooled system
1.
Locate the DIMM slot for installation. Ensure that the DIMM ejection tabs at both ends of the DIMM
slot are pushed outward to the open position (see Letter A).
2.
Carefully unpack the replacement DIMM, taking care to only handle the device by its outer edges.
3.
Align the notch at the bottom edge of the DIMM with the key in the DIMM slot (see Letter B).
