Intel® Server System S9200WK Product Family Setup and Service Guide
40
4.5.1
M.2 Heat Sink Removal
The riser assembly includes an M.2 heat sink that must be removed prior to servicing any M.2 SSD.
Figure 35. Removing the M.2 heat sink
1.
Locate the heat sink on the left side of the riser assembly and remove the screw (see Letter A).
2.
Slide the heat sink in the direction shown to remove it (see Letter B).
4.5.2
M.2 SSD Removal
Figure 36. Removing the M.2 SSD
1.
Remove the screw from the M.2 mounting stand-off on the left side of the riser assembly (see Letter
A).
2.
Carefully rotate outward the free end of the M.2 SSD away from the riser assembly (see Letter B
).
3.
Grasp the M.2 SSD by its edges and gently remove it from the connector in the direction shown (see
Letter C).
If no SSD is being installed:
4.
Return the previously removed screw to the M.2 mounting stand-off.
5.
Re-Install the M.2 heat sink on to the riser assembly (see Section 4.5.4).
1U Riser Assembly
2U Riser Assembly
1U Riser Assembly
2U Riser Assembly
