Intel S2600CW, Технические характеристики продукции

Страница: 159 / 210

Intel® Server Board S2600CW Family TPS Power Supply Specification Guidelines
Revision 2.4 145
10.3.2.11 DC/DC Converter Capacitive Loading
The DC/DC converters are stable and meet all requirements with the following capacitive
loading ranges. Minimum capacitive loading applies to static load only.
Table 81. Capacitive Loading Conditions
Converter Output Min Max Units
+3.3VDC 250 6800 µ F
+5VDC 400 4700
µ F
5Vstby 20 350
µ
F
10.3.2.12 DC/DC Converters Closed Loop Stability
Each DC/DC converter is unconditionally stable under all line/load/transient load conditions
including capacitive load ranges specified in Section 10.3.2.11. A minimum of: 45 degrees
phase margin and -10dB-gain margin is required. The PDB provides proof of the unit’s
closed-loop stability with local sensing through the submission of Bode plots. Closed-loop
stability must be ensured at the maximum and minimum loads as applicable.
10.3.2.13 Common Mode Noise
The Common Mode noise on any output does not exceed 350mV pk-pk over the frequency
band of 10Hz to 20MHz.

The measurement shall be made across a 100Ω resistor between each of DC outputs,
including ground, at the DC power connector and chassis ground (power subsystem
enclosure).

The test set-up shall use a FET probe such as Tektronix* model P6046 or equivalent.
10.3.2.14 Ripple/Noise
The maximum allowed ripple/noise output of each DC/DC Converter is defined in the table
below. This is measured over a bandwidth of 0Hz to 20MHz at the PDB output connectors. A
10 µ F tantalum capacitor in parallel with a 0.1 µ F ceramic capacitor are placed at the point of
measurement.
Table 82. Ripple and Noise
+3.3V +5V -12V +5VSB
50mVp-p 50mVp-p 120mVp-p 50mVp-p
The test setup shall be as shown below.