Intel RS2WC080, Руководство пользователя по оборудованию

Страница: 24 / 44

14 Intel® RAID Controller RS2BWC080 Hardware User’s Guide
Technical Specifications
Table 2. Technical Specifications
TP1 4-pin connector Universal Asynchronous
Receiver/Transmitter (UART)
Reserved for factory use
U1 2-pin connector RAID Premium Feature Key header.
Enables support for RAID premium
feature.
Jumper Type Description
Specification Intel
®
RAID Controller RS2WC080
I/O Processor Chip LSI*SAS2008 PCI* Express-SAS/SATA I/O Processor chip,
150MHz
Operating voltage +3.3 V, +12 V
Card size Low profile, extended half-length (6.6" x 2.731")
Array interface to host PCI Express* Revision 2.0, x8 lane width 5.0 Gb/s
SAS/SATA bus speed Up to 6 Gb/s per port, point-to-point
SAS/SATA ports 2x4 internal ports, up to 64 devices with expanders
Physical and virtual drive
support Up to 64 physical drives including up to 16 physical drives in
up to 16 RAID arrays per controller
Drives not configured as part of a RAID array can be
configured as “pass through” drives in Non-RAID mode.
Firmware Up to 16 MB in reflashable flash ROM
Compatible devices
•
2.5-inch and 3.5-inch SAS or SATA II drives including SSD
drives
•
Non disk devices including expanders
•
Can support drives of mixed capacity
Cabling
•
Small, thin cables that do not restrict airflow
•
Shared connectors for multiple drives
Redundant configuration 32 KB NVRAM and config-on-disk (COD)
Enclosure management
•
In-band SES
•
SGPIO
Enclosure support Assumes one SEP per enclosure