Intel R2000WT, Руководство по системной интеграции и обслуживанию

Страница: 114 / 140

Intel
®
Server System R2000WT Product Family System Integration and Service Guide
98
7.5 Replacing the Server Board
7.5.1 Server Board Removal
•
Power off system and remove power cords from each power supply module
• Disconnect all externally attached cables
•
Remove the system cover (see section 2.2.1)
• Remove power supply modules (see section 3.2.2)
•
(If Installed) remove all cables from devices mounted to the air duct
•
Remove air duct (see section 2.3.1)
•
Remove System Fan Assembly (see section 2.4.1)
•
Disconnect all cables attached to add-in PCIe add-cards and I/O modules
• Remove riser card assemblies (see section 2.8.1)
•
Remove all options installed onto the server board including (if installed): Intel® I/O Module, Intel® SAS
RAID Module, Intel® RAID 5 option key, Intel® RMM 4 Lite key, TPM Module, eUSB SSD
•
Remove Processors (see section 2.5)
•
Remove all DIMMs (see section 2.6.3)
• Disconnect and clear from the server board area all cables attached to connectors on the server board
•
Remove the two air duct sidewalls located on each side of the server board
• Remove nine fastener screws used to secure the server board to the chassis (see letter ‘A’)
Figure 102. Server Board Removal
•
Carefully lift server board from the chassis and place into anti-static bag