Intel R1304BTLSFAN, Руководство по обслуживанию

Страница: 72 / 112

52 Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide
6. If you need to add or replace a PCIe* Riser connector, see “Installing and
Removing a PCI Add-in Card” on page 55 .
7. If you need to add or replace a PCI add-in card, see “Installing and Removing a PCI
Add-in Card” on page 55 .
8. If you removed the PCIe* Riser assembly for another procedure, continue with that
procedure.
Installing the PCIe* Riser Assembly
Note: For clarity, the figures in this series of instructions does not show an attached add-in
card. If you are installing an add-in card, do so before installing the PCIe* riser assembly
into your server system.
1. Lower the riser assembly into place over the add-in card slot. See letter “B” in
Figure 31 .
2. Align the three hooks in the riser assembly with the matching slots at the back of
the server system. See letter “A” in Figure 31 .
Figure 31. Installing PCIe* Riser Assembly into the Server System
3. Press down uniformly until the two hooks on the rear of the PCIe* riser assembly
engage the server system back panel slots. The riser cards will seat into the
matching sockets on the server board.
4. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.
5. Install the server system cover. For instructions, see “Installing the Server System
Cover” on page 29 .
AF003695
PCI Riser
Socket
B
A
Riser Card
Connector